Knowledge Test Class A

This license is required for driving any legal combination of vehicles, with a gross combination weight rating of 26,001 pounds or more, provided the GVWR of a trailer exceeds 10,000 pounds To receive this license, applicants must pass a 50-question.. Read More

This license is required for driving any legal combination of vehicles, with a gross combination weight rating of 26,001 pounds or more, provided the GVWR of a trailer exceeds 10,000 pounds To receive this license, applicants must pass a 50-question test. To pass, applicants must answer 40 questions correctly. Each question has three or four possible answer choices. Test questions come from the Maryland Commercial Driver License Manual. Questions come from chapters covering: Introduction, Driving Safely, Transporting Cargo Safely, Air Brakes (if applicable), Pre-Trip Vehicle Inspection Test, Basic Vehicle Control Skills Test and On-Road Driving.. Endorsements that may be used with a Class A CDL are: Hazardous materials, Tank, Passenger, HazMat and Tank, Air Brakes and School bus.

Number of Question
Passing Score

8. How should you brake if your vehicle loses its ABS?

Explanation
An Anti-Lock Braking System (ABS) is in place as an addition to a braking system. It intervenes to prevent brakes from locking up during hard braking. If ABS is not working, the basic braking functions on a vehicle will still remain, so the driver can continue to drive and brake normally.

9. On a leaf spring:

Explanation
When inspecting your vehicle's suspension, verify that leaf springs do not have missing or broken leaves. If at least one-fourth of the leaves in a leaf spring are missing, the vehicle will be put out-of-service until the defect is fixed.

10. When asked to complete a conventional parallel parking maneuver, you should:

Explanation
You may be asked to complete a conventional parallel parking maneuver into a parking space that is to the right of your vehicle. You should drive past the parking space before backing into it while bringing the rear of your vehicle as close to the rear of the space as possible. Your vehicle should be completely within the boundaries of the space.

11. If a load is 10 feet long, it should be secured by a minimum of:

Explanation
Cargo should be restrained by at least one tie-down for every 10 feet of cargo. However, all cargo should have at least two tie-downs, no matter the size of the cargo.

12. If you are driving so slowly that you could impede other vehicles, you should:

Explanation
If you must drive slowly, you should use your emergency flashers to warn other drivers. Be sure that the use of emergency flashers is permitted by local laws.

13. In a vehicle with dual parking control valves, once air pressure is lost and the spring brakes come on:

Explanation
In a vehicle with dual parking control valves, there is a separate air tank that can be used to temporarily release the spring brakes if they have been activated due to low air pressure. Pushing in the proper control will release the spring brakes for a short period of time, allowing the driver to move the vehicle in an emergency.

14. To change lanes, you should:

Explanation
Always change lanes slowly and smoothly. If you did not see drivers who are already using the lane you wish to occupy, this will give them a chance to get out of your way or honk their horns to alert you. Always signal when changing lanes.

Frequently Asked Questions

A Class A Commercial Driver's License (CDL) is a type of license that allows a driver to operate a combination of vehicles with a gross vehicle weight rating (GVWR) of 26,001 pounds or more. This includes vehicles such as tractor-trailers, tanker trucks, and flatbed trucks. In Maryland, to obtain a Class A CDL license, you must meet the following requirements:

1. Be at least 18 years of age (21 years of age for interstate driving).
2. Hold a valid Maryland driver's license.
3. Pass a vision test.
4. Pass a knowledge test and obtain a Commercial Learner's Permit (CLP).
5. Complete a Maryland-approved CDL training program or provide proof of equivalent training.
6. Pass a skills test, which includes pre-trip vehicle inspection, basic control skills, and on-road driving test.
7. Submit to a medical examination and provide proof of meeting Federal Motor Carrier Safety Administration (FMCSA) medical standards.

Once you have met these requirements, you can apply for a Class A CDL license at any Maryland Motor Vehicle Administration (MVA) branch office.

With a Class A CDL license in Maryland, you can operate combination vehicles with a gross vehicle weight rating (GVWR) of 26,001 pounds or more, provided the vehicle you are towing has a GVWR of 10,001 pounds or more. This includes:

1. Tractor-trailers
2. Truck and trailer combinations
3. Livestock carriers
4. Flatbed trucks with attached trailers
5. Tanker trucks
6. Large passenger buses (with endorsements)

It's important to note that there are also certain endorsements you may need to operate specific types of vehicles, such as hazardous materials or passenger endorsements. Be sure to check with the Maryland Motor Vehicle Administration (MVA) for more information on specific requirements and endorsements needed for the type of vehicle you plan to operate.

To obtain a Class A CDL license in Maryland, you must meet the following requirements:

1. Be at least 18 years old (21 years old for interstate driving).
2. Hold a valid Maryland driver's license.
3. Pass a vision test.
4. Pass a written knowledge test and obtain a Commercial Learner's Permit (CLP).
5. Complete a Maryland-approved CDL training program or provide proof of equivalent training.
6. Pass a skills test, which includes pre-trip vehicle inspection, basic control skills, and on-road driving test.
7. Submit to a medical examination and provide proof of meeting Federal Motor Carrier Safety Administration (FMCSA) medical standards.

It's important to note that there are also certain endorsements you may need to operate specific types of vehicles, such as hazardous materials or passenger endorsements. Additionally, you must have a clean driving record and be able to pass a background check. Once you have met these requirements, you can apply for your Class A CDL license at any Maryland Motor Vehicle Administration (MVA) branch office.

The minimum age requirement for a Class A CDL license in Maryland is 18 years old, but there are restrictions for drivers under the age of 21. Drivers between the ages of 18 and 21 can only operate commercial vehicles within the state of Maryland and cannot transport hazardous materials or operate double or triple trailers. Additionally, they are not eligible to obtain a passenger endorsement for their CDL license.

For drivers who are 21 years old or older, there are no restrictions on interstate travel or the types of vehicles they can operate with a Class A CDL license. However, specific endorsements may have additional age requirements. It's important to check with the Maryland Motor Vehicle Administration (MVA) for specific information on age requirements for endorsements and other restrictions that may apply to young drivers with a Class A CDL license.

Whether you need any endorsements for your Class A CDL license depends on the type of vehicle you plan to operate.

In Maryland, there are several endorsements available for a Class A CDL license, including:

1. H (Hazardous Materials): Required if you plan to transport hazardous materials as defined by the Federal Motor Carrier Safety Administration (FMCSA).

2. N (Tank Vehicles): Required if you plan to transport liquids or gases in bulk containers with a capacity of 1,000 gallons or more.

3. P (Passenger): Required if you plan to drive vehicles designed to transport 16 or more passengers, including the driver.

4. S (School Bus): Required if you plan to drive a school bus.

5. T (Double/Triple Trailers): Required if you plan to tow double or triple trailers.

To obtain an endorsement, you must pass a knowledge test related to the specific type of vehicle or cargo you will be transporting and meet any additional requirements set forth by the FMCSA. You will also need to pay an additional fee for each endorsement.

It's important to note that some employers may require certain endorsements even if they are not legally required, so it's always a good idea to check with your employer or potential employer for specific requirements.

The Class A CDL skills test in Maryland consists of three parts: a pre-trip inspection, a basic control skills test, and an on-road driving test.

1. Pre-Trip Inspection: You will be required to perform a thorough inspection of your vehicle to ensure that it is safe to operate on the road. This test includes checking various components of the vehicle, such as the brakes, tires, lights, and coupling devices.

2. Basic Control Skills Test: You will be required to demonstrate your ability to control the vehicle in several different situations, including straight-line backing, offset backing, and parallel parking.

3. On-Road Driving Test: You will be required to drive the vehicle on public roads while being evaluated on your ability to safely operate the vehicle in traffic. The test will include driving in various traffic situations such as intersections, railroad crossings, and highway driving.

During the skills test, you will be evaluated by a licensed examiner who will score you based on your performance. To pass the skills test and obtain your Class A CDL license in Maryland, you must pass all three parts of the skills test with a minimum score of 80% on each section.

It's important to note that you must hold a valid commercial learner's permit (CLP) for at least 14 days before taking the skills test. Additionally, you must provide your own Class A commercial vehicle for the skills test or arrange for a rental through an approved third-party provider.

Yes, there are restrictions or limitations for drivers with a Class A CDL license in Maryland. Some of the restrictions or limitations include:

1. Automatic Transmission Restriction: If you took the skills test in a vehicle with an automatic transmission, you will have an "E" restriction on your license, which means you are only authorized to operate vehicles with automatic transmissions.

2. Air Brake Restriction: If you took the skills test in a vehicle without air brakes, you will have an "L" restriction on your license, which means you are not authorized to operate vehicles with air brakes.

3. Intrastate Only Restriction: If you only plan to operate commercial vehicles within Maryland, you will have an "O" restriction on your license, which means you are only authorized to operate commercial vehicles within the state.

4. Hazmat Endorsement Restriction: If you have a hazardous materials (H) endorsement on your license, there may be additional restrictions or limitations related to the transportation of hazardous materials.

It's important to note that there may be additional restrictions or limitations based on federal regulations and individual employer policies. It's always a good idea to check with your employer or potential employer for specific requirements and restrictions.

In Maryland, the Class A CDL written test is available in several languages other than English, including Spanish, French, Korean, and Chinese. However, it's important to note that the skills test for a Class A CDL license must be taken in English.

If you wish to take the written test in a language other than English, you must notify the Maryland Motor Vehicle Administration (MVA) when you schedule your appointment. You may be required to provide an interpreter if one is not available at the MVA.

It's important to note that even if you take the written test in a language other than English, you will still be required to demonstrate your ability to read and understand English during the skills test. The skills test examiner will provide instructions and communicate with you in English during the test.

Yes, you can request accommodations for the Class A CDL written test in Maryland if you have a disability that may affect your ability to take the test. The Maryland Motor Vehicle Administration (MVA) provides reasonable accommodations to ensure that all individuals have an equal opportunity to obtain a driver's license.

To request accommodations, you must submit a Request for Accommodation form to the MVA. The form is available on the MVA website and can be submitted online or by mail.

The Request for Accommodation form must be completed by a qualified professional who can verify your disability and describe the accommodations you need. The MVA will review your request and determine if the requested accommodations are appropriate and necessary.

Examples of accommodations that may be provided include extended testing time, a separate testing room, a sign language interpreter, or an assistive technology device.

It's important to note that requests for accommodations must be submitted in advance of your scheduled test date to allow sufficient time for review and approval.

Yes, if you fail the Class A CDL written test in Maryland, you can retake it. However, you must wait at least one day before you can retake the test.

If you fail the test, the Maryland Motor Vehicle Administration (MVA) will provide a score report that shows your strengths and weaknesses. This report can help you focus your studying and prepare for the retake.

It's important to note that there is a fee for each attempt at the written test. Before you retake the test, make sure to review the Maryland CDL Manual and study any areas where you struggled.

If you fail the test three times, you will be required to wait at least 7 days before you can attempt it again. If you fail the test six times, you will be required to wait at least 30 days before you can attempt it again.

Keep in mind that passing the written test is only one step in obtaining a Class A CDL license. You will also need to pass a skills test, which includes a pre-trip inspection, basic control skills, and a road test.
DMV Writen Test