Instructions

Combination

All applicants who are applying for a Class A CDL should be prepared to take the Combination test. This test covers information found in Section 6 of the Commercial Driver License.. Read More

All applicants who are applying for a Class A CDL should be prepared to take the Combination test. This test covers information found in Section 6 of the Commercial Driver License Manual. Section 6 provides the information needed to safely operate tractor-trailers, doubles, triples, and straight trucks with trailers. The test is made up of 20 multiple-choice questions, and applicants will need to correctly answer a minimum of 16 questions to pass. The Combination test is not a replacement for the Double/Triple endorsement test.

Number of Question 20

Passing Score 16

8. After coupling, there should be ____ between the upper and lower fifth wheel.

No space

Very little space

A lot of space

Three inches of space

Before a trip, be sure to inspect all couplings. There should be no space between the upper and lower fifth wheel.

9. During a trip, landing gear should be:

Completely raised.

Completely lowered.

Skimming the pavement.

Landing gear, or trailer supports, should always be completely raised before a vehicle is driven. Landing gear that is not entirely raised could catch on railroad tracks or other hazards on the roadway.

10. The trailer hand valve should be used:

To test the trailer brakes.

To check the connection between the trailer and tractor.

To accelerate.

The trailer hand valve (also referred to as the "trolley valve" or "Johnson bar") works the trailer brakes and should be used only when testing them. Using the trailer hand valve while driving could result in a skid.

11. Shut-off valves:

Prevent air from escaping air brake systems.

Prevent air from entering air brake systems.

Override vehicles that are out of control.

Shut-off valves are used in air supply lines to control the passage of air from one trailer to another. The rear shut-off valve should always be closed to prevent air from leaving the braking system.

12. To help prevent rollovers, you should:

Accelerate quickly after stopping.

Drive slowly around turns.

Keep the load near the back of the trailer.

Keep the load on one side of the trailer.

To lower the risk of a rollover, load your cargo as closely to the ground as possible. To further reduce this risk, take curves and corners slowly.

13. When entering or crossing traffic while driving a combination vehicle, it is especially important that you:

Sound your horn.

Make sure there is a large enough gap for your vehicle.

Expect other drivers to make room for your vehicle.

Let other drivers wave you into their lane.

Combination vehicles require more space on the road than other vehicles. When entering or crossing traffic while driving a combination vehicle, it is especially important that there is a large enough gap in traffic for you to safely do so.

14. Operating combination vehicles usually requires ____ operating single vehicles.

Less skill than

About the same level of skill as

More skill than

Combination vehicles are usually heavier and longer than single combination vehicles. Operating a combination vehicle requires a higher level of driving skill than operating a single commercial vehicle.

Grade This Section

See the exact questions that will be on the 2024 South Carolina DMV exam.

99.2% of people who use the cheat sheet pass the FIRST TIME

Click Here
Full Cheat Sheet Unlock Your Exclusive Cheat Sheet!