Knowledge Test Class A
This license is required for driving any legal combination of vehicles, with a gross combination weight rating of 26,001 pounds or more, provided the GVWR of a trailer exceeds 10,000 pounds To receive this license, applicants must pass a 50-question test. To pass, applicants must answer 40 questions correctly. Each question has three or four possible answer choices. Test questions come from the Commercial Driver License Manual. Questions come from chapters covering: Introduction, Driving Safely, Transporting Cargo Safely, Air Brakes (if applicable), Pre-Trip Vehicle Inspection Test, Basic Vehicle Control Skills Test and On-Road Driving.. Endorsements that may be used with a Class A CDL are: Hazardous materials, Tank, Passenger, HazMat and Tank, Air Brakes and School bus.
Number of Question
Passing Score
22. After a vehicle is started, warning lights and buzzers:
Explanation
After starting the engine, warning lights and buzzers should go out right away. If a light stays on, it usually indicates an issue with the vehicle.
23. When alley docking, you should first:
Explanation
If you are asked to alley dock, you should first pull past the alley and stop your vehicle in a position that is parallel to the outer boundary. From there, you should back your vehicle entirely into the alley parking area. Your vehicle should be parked in a straight position within the boundaries of the parking space.
24. What should be done before transporting an over-length load?
Explanation
Over-length, over-width, and/or overweight loads may require special permits from the Department of Transportation.
25. Most heavy trucks with manual transmissions require ____ to change gears.
Explanation
Most heavy vehicles with manual transmissions require double clutching to shift gears. Learning to effectively change gears by double clutching takes practice.
26. Rust around wheel nuts may mean:
Explanation
Rust around wheel nuts can indicate that the nuts are loose. If you find rust near the wheel nuts, check their tightness before beginning to drive.
27. When approaching a vehicle for a pre-trip inspection, a driver should look under the vehicle:
Explanation
When approaching your vehicle before an inspection, make note of its general condition and ensure that it is not damaged or leaning. Look under the vehicle for fresh leaks of oil, grease, or fuel. Check around the vehicle for hazards to movement, such as people, other vehicles, or low-hanging wires or tree limbs.
28. Which of the following is acceptable if found during a pre-trip inspection?
Explanation
When inspecting your tires, verify that there is tread depth of at least 4/32 of an inch in every major groove on the front tires and tread depth of at least 2/32 of an inch in grooves on the other tires. Be sure that your tires are not too worn, are not cracked, have proper air pressure, and are all equally sized.
Frequently Asked Questions
A Class A CDL (Commercial Driver's License) license in Tennessee allows an individual to operate a combination of vehicles with a gross vehicle weight rating (GVWR) of 26,001 pounds or more, provided the GVWR of the vehicle being towed is more than 10,000 pounds. It also allows an individual to operate vehicles that fall under Class B and Class C categories. Examples of vehicles that may require a Class A CDL include tractor-trailers, tanker trucks, and livestock carriers. To obtain a Class A CDL license in Tennessee, an individual must pass a series of knowledge and skills tests as well as meet other requirements such as age, medical certification, and driving record.
With a Class A CDL license in Tennessee, you can operate a combination of vehicles with a Gross Vehicle Weight Rating (GVWR) of 26,001 pounds or more. This includes:
- Tractor-trailers
- Truck and trailer combinations
- Livestock carriers
- Tanker trucks
- Flatbed trucks
- Dump trucks with trailers
- Logging trucks with trailers
- Car carriers with trailers
Additionally, a Class A CDL license in Tennessee also allows you to operate vehicles in the Class B and Class C categories, provided you have the appropriate endorsements. This expands your driving privileges to include buses, passenger vans, and vehicles transporting hazardous materials.
- Tractor-trailers
- Truck and trailer combinations
- Livestock carriers
- Tanker trucks
- Flatbed trucks
- Dump trucks with trailers
- Logging trucks with trailers
- Car carriers with trailers
Additionally, a Class A CDL license in Tennessee also allows you to operate vehicles in the Class B and Class C categories, provided you have the appropriate endorsements. This expands your driving privileges to include buses, passenger vans, and vehicles transporting hazardous materials.
To obtain a Class A CDL (Commercial Driver's License) license in Tennessee, you must meet the following requirements:
1. Age: You must be at least 18 years old to operate a commercial vehicle within Tennessee, and 21 years old to operate a commercial vehicle outside the state.
2. Valid driver’s license: You must have a valid driver’s license issued by the state of Tennessee.
3. Medical certification: You must pass a medical exam and obtain a medical certificate from a certified medical examiner to ensure you are physically able to operate a commercial vehicle.
4. Knowledge tests: You must pass a series of knowledge tests, including general knowledge, air brakes, and combination vehicles.
5. Skills tests: You must pass a series of skills tests, including pre-trip inspection, basic vehicle control, and on-road driving.
6. Background check: You must pass a background check and be free of any disqualifying criminal offenses.
7. Fees: You must pay the appropriate fees for the application, testing, and licensing process.
It is also important to note that you may need to obtain additional endorsements on your CDL license for certain types of vehicles or cargo, such as hazardous materials or passenger transport.
1. Age: You must be at least 18 years old to operate a commercial vehicle within Tennessee, and 21 years old to operate a commercial vehicle outside the state.
2. Valid driver’s license: You must have a valid driver’s license issued by the state of Tennessee.
3. Medical certification: You must pass a medical exam and obtain a medical certificate from a certified medical examiner to ensure you are physically able to operate a commercial vehicle.
4. Knowledge tests: You must pass a series of knowledge tests, including general knowledge, air brakes, and combination vehicles.
5. Skills tests: You must pass a series of skills tests, including pre-trip inspection, basic vehicle control, and on-road driving.
6. Background check: You must pass a background check and be free of any disqualifying criminal offenses.
7. Fees: You must pay the appropriate fees for the application, testing, and licensing process.
It is also important to note that you may need to obtain additional endorsements on your CDL license for certain types of vehicles or cargo, such as hazardous materials or passenger transport.
Yes, you may need to obtain additional endorsements on your CDL license for certain types of vehicles or cargo. The following are the endorsements you may need for a Class A CDL in Tennessee:
1. Combination vehicles (double/triple trailers): This endorsement is required if you plan to operate a combination of vehicles with two or three trailers.
2. Tanker: This endorsement is required if you plan to transport liquids or gases in bulk containers with a capacity of 1,000 gallons or more.
3. Hazardous materials: This endorsement is required if you plan to transport hazardous materials as designated by the U.S. Department of Transportation.
4. Passenger: This endorsement is required if you plan to operate a vehicle designed to transport 16 or more passengers, including the driver.
To obtain these endorsements, you must pass additional knowledge and skills tests specific to each endorsement. It is important to note that some endorsements may also require background checks and additional fees.
1. Combination vehicles (double/triple trailers): This endorsement is required if you plan to operate a combination of vehicles with two or three trailers.
2. Tanker: This endorsement is required if you plan to transport liquids or gases in bulk containers with a capacity of 1,000 gallons or more.
3. Hazardous materials: This endorsement is required if you plan to transport hazardous materials as designated by the U.S. Department of Transportation.
4. Passenger: This endorsement is required if you plan to operate a vehicle designed to transport 16 or more passengers, including the driver.
To obtain these endorsements, you must pass additional knowledge and skills tests specific to each endorsement. It is important to note that some endorsements may also require background checks and additional fees.
The Class A CDL skills test in Tennessee consists of three parts:
1. Pre-trip inspection: You will be required to perform a thorough inspection of your commercial vehicle, including checking the brakes, tires, lights, and other safety equipment. You will need to identify any defects or malfunctions and explain how you would correct them.
2. Basic vehicle control: You will be required to demonstrate your ability to control your commercial vehicle in a variety of situations, such as backing up, turning, and parking.
3. On-road driving: You will be required to demonstrate your ability to safely operate your commercial vehicle in real traffic situations. This includes merging onto highways, changing lanes, turning at intersections, and responding to traffic signals and signs.
You will be graded on your ability to perform each part of the skills test safely and correctly. It is important to practice and prepare for the skills test before taking it. You may also be required to bring your own commercial vehicle for the skills test.
1. Pre-trip inspection: You will be required to perform a thorough inspection of your commercial vehicle, including checking the brakes, tires, lights, and other safety equipment. You will need to identify any defects or malfunctions and explain how you would correct them.
2. Basic vehicle control: You will be required to demonstrate your ability to control your commercial vehicle in a variety of situations, such as backing up, turning, and parking.
3. On-road driving: You will be required to demonstrate your ability to safely operate your commercial vehicle in real traffic situations. This includes merging onto highways, changing lanes, turning at intersections, and responding to traffic signals and signs.
You will be graded on your ability to perform each part of the skills test safely and correctly. It is important to practice and prepare for the skills test before taking it. You may also be required to bring your own commercial vehicle for the skills test.
Yes, there are certain restrictions and limitations for drivers with a Class A CDL license in Tennessee. These include:
1. Age restrictions: To obtain a Class A CDL, you must be at least 18 years old. However, you will only be able to operate commercial vehicles within the state of Tennessee until you are 21 years old.
2. Vehicle weight: You may be limited to operating commercial vehicles that weigh less than 26,001 pounds with a Class A CDL.
3. Endorsement restrictions: As mentioned earlier, certain endorsements may be required for specific types of vehicles or cargo. If you do not have the necessary endorsements, you will be restricted from operating those types of vehicles.
4. Medical requirements: You must pass a medical examination every two years to maintain your Class A CDL. If you have certain medical conditions, such as diabetes or high blood pressure, you may need to obtain a medical waiver to continue driving.
5. Alcohol and drug use: You may not operate a commercial vehicle with a blood alcohol concentration (BAC) of 0.04% or higher. You may also be subject to random drug and alcohol testing by your employer or the federal government.
It is important to follow all restrictions and limitations associated with your Class A CDL license to ensure your safety and the safety of others on the road.
1. Age restrictions: To obtain a Class A CDL, you must be at least 18 years old. However, you will only be able to operate commercial vehicles within the state of Tennessee until you are 21 years old.
2. Vehicle weight: You may be limited to operating commercial vehicles that weigh less than 26,001 pounds with a Class A CDL.
3. Endorsement restrictions: As mentioned earlier, certain endorsements may be required for specific types of vehicles or cargo. If you do not have the necessary endorsements, you will be restricted from operating those types of vehicles.
4. Medical requirements: You must pass a medical examination every two years to maintain your Class A CDL. If you have certain medical conditions, such as diabetes or high blood pressure, you may need to obtain a medical waiver to continue driving.
5. Alcohol and drug use: You may not operate a commercial vehicle with a blood alcohol concentration (BAC) of 0.04% or higher. You may also be subject to random drug and alcohol testing by your employer or the federal government.
It is important to follow all restrictions and limitations associated with your Class A CDL license to ensure your safety and the safety of others on the road.
In Tennessee, the Class A CDL written test is offered in English only. However, you may be able to bring an interpreter with you to assist you with the test. The interpreter must be fluent in both English and the language that you prefer to use. The interpreter cannot help you answer the questions but can only translate the questions and answers for you.
It is important to note that if you choose to use an interpreter, you must provide them yourself and they must be approved by the Department of Safety and Homeland Security. You will also need to let the testing center know in advance if you plan to use an interpreter so that they can make appropriate arrangements.
Also, it is recommended that you have a good understanding of English, as many road signs and instructions are in English. It is essential to have a good knowledge of the language to pass the written test and operate a commercial vehicle safely on Tennessee roads.
It is important to note that if you choose to use an interpreter, you must provide them yourself and they must be approved by the Department of Safety and Homeland Security. You will also need to let the testing center know in advance if you plan to use an interpreter so that they can make appropriate arrangements.
Also, it is recommended that you have a good understanding of English, as many road signs and instructions are in English. It is essential to have a good knowledge of the language to pass the written test and operate a commercial vehicle safely on Tennessee roads.
Yes, you can request accommodations for the Class A CDL written test in Tennessee if you have a disability that may affect your ability to take the test. The Department of Safety and Homeland Security provides reasonable accommodations to individuals with disabilities in compliance with the Americans with Disabilities Act (ADA).
To request accommodations, you will need to contact the Department of Safety and Homeland Security’s Driver Services Division at least 30 days before your scheduled test date. You will need to provide documentation of your disability and describe the specific accommodations you need.
Examples of accommodations that may be provided include extended testing time, a separate testing room, or a sign language interpreter. The department will work with you to determine the appropriate accommodations based on your disability and needs.
It is important to note that accommodations are provided on a case-by-case basis and are subject to approval by the department. You should also be aware that some accommodations may require additional fees or scheduling considerations.
To request accommodations, you will need to contact the Department of Safety and Homeland Security’s Driver Services Division at least 30 days before your scheduled test date. You will need to provide documentation of your disability and describe the specific accommodations you need.
Examples of accommodations that may be provided include extended testing time, a separate testing room, or a sign language interpreter. The department will work with you to determine the appropriate accommodations based on your disability and needs.
It is important to note that accommodations are provided on a case-by-case basis and are subject to approval by the department. You should also be aware that some accommodations may require additional fees or scheduling considerations.
Yes, if you fail the Class A CDL written test in Tennessee, you are allowed to retake it. However, there are some restrictions on how many times you can retake the test.
If you fail the test, you will need to wait at least one day before retaking it. If you fail the test three times, you will be required to wait at least 30 days before taking the test again. If you fail the test more than three times, you will be required to wait at least six months before taking it again.
It's important to note that there is a fee for each attempt at the Class A CDL written test. Therefore, it's important to prepare thoroughly for the test before taking it to avoid having to pay additional fees for retakes.
If you are having difficulty passing the Class A CDL written test, there are resources available to help you prepare. You can find study materials and practice tests online, or consider enrolling in a commercial driver's license training program.
If you fail the test, you will need to wait at least one day before retaking it. If you fail the test three times, you will be required to wait at least 30 days before taking the test again. If you fail the test more than three times, you will be required to wait at least six months before taking it again.
It's important to note that there is a fee for each attempt at the Class A CDL written test. Therefore, it's important to prepare thoroughly for the test before taking it to avoid having to pay additional fees for retakes.
If you are having difficulty passing the Class A CDL written test, there are resources available to help you prepare. You can find study materials and practice tests online, or consider enrolling in a commercial driver's license training program.
